Bay Networks 5390 Administering page 316

Communications server

Hide thumbs Also See for 5390:

Table of Contents

Internet Protocol (IP) Routing

For network_list, specify up to eight IP network addresses, separated by commas (no spaces are

allowed anywhere in the list).

Instead of access_spec, you can enter none or all; none speciﬁes that no RIP updates are advertised

over the interface, while all speciﬁes that RIP updates are advertised for all network addresses. The

default is all.

The following admin example causes RIP to advertise routes for all destination addresses except

those on networks 10.0.0.0 and 190.9.200.0. The example applies to routes advertised over interfaces

asy3 through asy5:

annex# admin

Annex administration Remote Annex 10.1, 24 ports

admin: interface asy3-5

admin: set interface rip_advertise exclude\

10.0.0.0,190.9.0.0

You may need to reset the appropriate port, Annex

subsystem or reboot the Annex for changes to take effect.

admin: reset interface

If the above example contained the keyword include instead of exclude, RIP would advertise only

those routes whose destination networks were 10.0.0.0 and 190.9.0.0 and no others.

NOTE: When interpreting an address in network_list, RIP uses the

intrinsic subnet mask derived from the address class, regardless of the

port or the Model 5390 subnet_mask parameter setting.