Bay Networks 5390 Administering page 808

Software Reference
Table D1-1. All Parameters (continued)
Parameter
need_dsr
net_inactivity
net_inactivity_units
network_turnaround
newline_terminal
node_id
option_key
output_flow_control
output_is_activity
output_start_char
output_stop_char
D1-12
Values Default
Y or N N
0–255 0
minutes or minutes
seconds
1–10 2
Y or N N
0–65534.255 0.0
unique value no default
eia, start/stop, start/stop
bell, both, none
Y or N N
control char. ^Q
sequence
control char. ^S
sequence
Description
For use with a modem connected to a slave
port. When enabled, the connection fails if
no DSR signal is present; when disabled,
the Model 5390 server accepts the
connection, but waits for DSR and DCD
before communicating with the modem.
Defines the amount of time an
asynchronous port can remain inactive
before the port is reset.
Defines the units of time used for the port's
inactivity timer.
Sets the number of seconds to wait for an
answer from a security host.
Interprets carriage returns and line feeds at
the CLI level.
Contains the address the Model 5390
server tries to acquire at the start of an
AppleTalk session. If this address is in use,
the Model 5390 server must acquire a new
node ID. This new ID is stored in
non-volatile RAM.
Enables ARA, tn3270, active RIP, filtering,
and dial-out routing.
Defines method of flow control that the
terminal uses to stop output from the
Model 5390 server.
Defines activity as output.
Defines the character that restarts output.
Defines the control character sequence that
stops output.
893-741-B