Bay Networks 5390 Administering page 595

The syntax is:
reset annex [=annex_list] annex_subsystem
reset interface [=interface_list | keyword]
reset printer [=printer_port_list | keyword]
reset [port |asynchronous] [=async_port_list | keyword]
The allowed values for annex_subsystem are security, motd, nameserver, macros, dialout,
modem_table, lat, syslog, and all.
The reset t1 command resets the T1 engine and T1 statistics information. This command is used to
change the T1 engine's parameter configuration. The T1 soft, hard, and esf keywords are described
in Table C1-10. The syntax is:
reset t1 [soft | hard | esf]
The reset int_modem command (available from na or admin) resets the specified T1 modem_set.
There is no physical reset button. A modem reset forces the port to be reset. In addition, if the signal
protocol is set to wink start or immediate start, a special AT command is sent to the modem to select
the dialtone detection mechanism. The syntax is:
reset int_modem < modem_set >
The modem_set parameter specifies the individual modem numbers, separated by commas, or a
range of numbers separated by a hyphen. The valid modem number range is 1 to 24, inclusive.
893-741-B
Table C1-9. Keywords for the reset Command
Keyword Definition
all Resets all serial ports and virtual CLI connections.
annex all Resets the message-of-the-day, the security, name server,
LAT, and syslog subsystems, and customized user
interface macros.
na Commands
C1-19