Rip_Send_Version; Rip_Sub_Accept; Rip_Sub_Advertise - Bay Networks 5390 Administering

Communications server

Hide thumbs Also See for 5390:

Table of Contents

The following na command causes RIP to send updates to the routers at the following addresses:

132.254.33.4, 132.254.1.30, and 132.254.2.2. You must then reboot the Model 5390 server.

command: set annex rip_routers 132.254.33.4,132.254.1.30,132.254.2.2

Changes will take effect at next annex boot or

interface reset

command: boot

rip_send_version

The interface parameter rip_send_version controls which RIP versions the Model 5390 server

sends: 1 indicates version 1 packets are sent to the IP broadcast address; 2 indicates version 2 packets

are sent to the multicast address; and compatibility indicates version 2 packets are sent to the IP

broadcast address. The default is compatibility. For more information, see Advertising RIP 1 and/

or RIP 2 Updates on page A12-51.

The interface parameter rip_sub_accept controls whether or not subnet routes are accepted. A Y

accepts subnet routes; an N rejects them. The default is Y. For more information, see Advertising

Subnet Routes on page A12-51.

The interface parameter rip_sub_advertise parameter controls whether or not subnet routes are

advertised. A Y enables subnet advertising; an N disables it. The default is Y. For more information,

see Advertising Subnet Routes on page A12-51.

Internet Protocol (IP) Routing