Bay Networks 5390 Administering page 163

Communications server

Hide thumbs Also See for 5390:

Table of Contents

Use the supplied

defaults for the

data_bits (8),

stop_bits (1), and

parity (none)

After setting the port

parameters, reset the

appropriate port(s) or

Model 5390 subsystem,

or reboot the Model

5390 server for the

changes to take effect.

A sample command line

for conﬁguring ports 1

through 4 with the

minimum required

parameters for this set up

looks like this:

admin: port 1–4

admin: set port mode

slip speed 38400

control_lines both

input_flow_control eia

output_flow_control

admin: type dial_in

NOTE: SLIP is an 8-bit protocol. If data_bits is set to 7, and parity is

not set to none, the Model 5390 server forces the data_bits setting to 8

and the parity setting to none. Otherwise, the Model 5390 server gener-

ates an error message for the port.

Serial Line Internet Protocol (SLIP)