Bay Networks 5390 Administering page 743

893-741-B
Table C3-28. Setting Parameters Using the stty Command (continued)
Parameter Description
ilower Controls case conversion for characters sent from the terminal
–ilower to the Model 5390 server. Use is lower for older terminals
without lowercase characters. The Model 5390 server converts
typed uppercase characters to lowercase. The default, –ilower,
does not change case.
ixany Specifies that typing any character restarts the output to the
–ixany screen that was stopped with the XOFF character. The default
is –ixany.
lbreak Defines a long break as an attention signal; –lbreak turns off
–lbreak long break as an attention signal. The default is lbreak.
ldisp Sets the reprint line character. The default is
character
lera Sets the line erase character. The default is
character
newlin Defines the terminal as a new line terminal, which sends a
–newlin carriage return followed by a line feed when Return is pressed
and displays a carriage return followed by a line feed when a
line feed character is received. The default is
–newlin.
oflow Specifies the terminal's method for stopping output from the
argument Model 5390 server. The default is xonoff. Possible values are:
none No flow control; characters are lost if the buffers overflow.
eia Selects hardware flow control and works only if the
control_lines parameter is enabled for hardware flow control
and the terminal is wired appropriately.
xonoff Specifies XON/XOFF flow control. When the Model 5390
server receives XOFF, it stops sending output to the terminal;
when it receives XON, it starts sending output again. Setting
ostopc to
allows you to type these characters to stop and to start output
when something is about to scroll off the screen.
for XOFF and ostartc to
CTRL-S
Using the CLI Commands
.
CTRL-R
.
CTRL-U
for XON
CTRL-Q
C3-67