YASKAWA SGM Series User Manual page 13

J Operation
D Do not touch rotating parts of the Servomotor during operation.
Injury may result.
D In order to avoid accidents, do not connect the Servomotor shaft to the controlled equipment dur-
ing the trial operation.
Injury may result.
D Be sure to set the proper user constants for the controlled equipment prior to starting operation with
the Servomotor connected to the equipment.
Equipment overrun or damage may result without proper settings prior to the start of operation.
D Always set up an emergency stop prior to starting operation with the Servomotor connected to the
equipment.
Injury may result if an emergency stop is not readily available.
D Do not touch the heat sink area during operation.
Severe burns due to high temperatures may result.
J Maintenance and Inspection
D Do not touch areas inside the SERVOPACK.
Electric shock may result.
D Make sure the panel cover is attached when power is ON.
Electric shock may result if the panel cover is left open.
D Turn OFF power and wait 5 minutes before touching terminals.
Electric shock from residual voltage may result if terminals are touched within 5 minutes of turning OFF
power.
D Do not disassemble the Servomotor.
Electric shock or injury may result.
D Do not change wiring with the power turned ON.
Electric shock or injury may result.
WARNING
!
CAUTION
!
WARNING
!
CAUTION
!
xv
Safety Precautions