Caution - Ricoh MP C6502SP Field Service Manual

2. Installation
• Do not turn ON the write protect switch of the system SD card or application SD card on the
machine. If the write protect switch is ON, a download error (e.g. Error Code 44) occurs during a
firmware upgrade or application merge.
1. Turn the main switch off.
2. Insert the original SD card in SD Card Slot 2 [B]. The application program is copied back into this
card.
3. Insert the SD card with the application program in SD Card Slot 1 [A].The application program is
copied back from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-002 "Undo Exec."
7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the SD card from SD Card Slot 2 [B].
10. Turn the main switch on.
11. Check that the application programs run normally.

Caution

• If the customer uses the SD card on a PC, operation cannot be guaranteed.
• The SD card from which you moved an application cannot be used again.
• The SD card itself is the proof of purchase. Therefore, the application must be purchased again if
the card is lost.
448