Table of Contents
Advertisement
Introducing
the EP Component Central Monitor
System Controls and Connectors
a
Display Module
Power
On/Off
switch
indicator
light
onnector
contrast
brightness
for keyboard
control
control
cable
Display Module Front View
Adjusting
Screen Contrast and Brightness
The brightness and the contrast of the screen display can be adjusted by means of the two dials
underneath the hardkeys.
Follow this procedure to achieve the optimum screen display:
1. Turn the brightness and contrast controls to their maximum settings.
2. Slowly turn the brightness and contrast controls down to the lowest acceptable position
where
the display can still be seen clearly. The most acceptable position will be dependent
upon the surrounding light conditions.
Please ensure that all the screen information is visible.
Screen Messages
The top line of the Display Screen contains the system date and time and the message area.
There are two types of messages:
n
Prompt messages - these instruct the user to perform an action. Prompt messages appear for
3 seconds. (The prompt for
SekCting
a bed after pressing
bdmit/DischargeJ,
CPatient Window),
or
(Arrhythmia
Functions]
blinks and remains for several additional seconds.)
w Status messages - these give information about the current situation. For example:
Check paper/door
on This message remains until paper is reloaded in the recorder and the
Module Recorder
door is closed.
An
up
arrow indicates that there is more than one status message. Messages are displayed in
rotation for 3 seconds each.
The rear panel of the Display Module is shown below. The back of the Display Module should
only be removed by
qualilied service personnel.
l-15
Advertisement
Table of Contents
Troubleshooting
