Lb Remove The Rear Cover; Lb Replace The Rear Cover - HP M2350A Service Manual

Removing and Replacing Components
Servicing the Computer Module
'lb Remove the Rear Cover
The procedure for removing the rear cover is described in the following steps.
Step 1 Slide the two sprung locks towards the center of the cover and lift the lower edge
of the cover.
'__ '
Step 2
Lift the lower edge of the cover and lift the cover directly out on the rear of the
computer module.
Step 3 Lean the cover against the side of the chassis, allowing you to see the ground
connection to the computer module.
Step 4 Using a cross-tipped screwdriver, remove the large grounding screw from the
inside of the computer module. Make sure that you replace the two washers on
either side of the cable eyelet.
'lb Replace the Rear Cover
The procedure for replacing the rear cover is described in the following steps.
Step 1 Lean the cover against the side of the computer module such that you can connect
the ground wire to the case of the computer module.
Step 2
Using a cross-tipped screwdriver, replace the large grounding screw on the inside
of the computer module. Make sure that you replace the two washers either side
of the cable eyelet.
Step 3 Holding the cover vertically, locate the cover in to the back of the computer
module.
Step 4
Push the bottom of the cover Gmly into place and the two sprung locks click to
lock the cover into place.
12.28