HP M2350A Service Manual page 232

Troubleshooting the System
Troubleshooting Patient Location
Status Message
Y . . .
Location Badge
Already Assigned"
Y . . . Location Badge
Assigned "
" . . . Location Badge
Unassigned"
" . . . Location Badge #
is not valid"
Possible Cause
Action
The badge you are trying to use is already No action required.
assigned to a patient.
The badge has been successfully assigned to a No action required.
patient.
The badge has been successfully unassigned
No action required unless you want to assign
from a patient. the badge to another patient.
The badge number is not recognized by Check the number and enter it again. Check
SmartLinkTM, or the badge number is outside the conllguration to make sure it is correct.
the range of badge numbers con.Sgured during
system installation.
Y . . . Invalid Char-
acters in Location
Badge #"
You have entered non-numeric characters. Check badge number and reenter.
"Badge Not Assigned" You have not assigned a particular patient a Assign a badge to the patient in accordance
badge. with the badge numbers set up at
configuration.
"Not Current" This message gives you a date, time, hour, and This message is generally produced when the
minute (10 Ott 13:24, hours on a twenty four Patient
Locator
badge is covered or blocked.
hour format) of the last good known location. Check for any of the following:
This message is generated by SmartLinkTM
when the location of a patient is not seen by
m Patient lying on the badge.
the system for six seconds.
w Dead battery in the badge.
n
Badge out of range.
n
Patient leaving the coverage area.
n
Badge placed in a closet, drawer, or a
pocket.
If message persists across all patients, check
the Patient Location Status Log.
"Patient Left Area"
(High Priority)
"Locator Battery Lo"
(High Priority)
"Location Link Lost"
(High Priority)
This feature must be conilgured by
Fisher-Berkeley. This message tells you the
patient is no longer in the coverage area.
When the patient leaves the coverage area,
the last known location is displayed.
This message tells you the locator battery is
low and needs to be replaced.
This message tells you the CCM once had
communications with the SmartLinkTM
system, but the communication is lost.
Return patient to coverage area. If this
message persists check the Patient Location
Status Log. If any messages are logged, print
the log and give it to the Fisher Berkeley
service representative.
Replace the locator battery.
Verify the Fisher-Berkeley SmartLinkTM serial
cable is connected to the CCM's RS232/422
interface. Reseat the RS232 board on the CCM
to see if the problem goes away. Replace the
RS232 board if it does not. If the problem
persists, print the Patient Location Status Log
and contact Fisher-Berkeley service
representative.
"Chnm Failure"
(High Priority)
The CCM was unable to establish a connection Perform General Fault Isolation on the CCM.
with SmartLinkTM upon boot-up during a hot,
Verify the Fisher-Berkeley SmartLlnkTM serial
warm, or cold start. cable is connected to the CCM's RS232/422
interface. Reseat the RS232 board on the CCM
to see if the problem goes away. Replace the
RS232 board if it does not. If the problem
persists, print the Patient Location Status Log
and contact Fisher-Berkeley service
representative.
9-8