HP M2350A Service Manual page 169

Mounting the Components
Installing A-Option Mounts
Figure 6-25. MllSOA # A26
lb Install the Wall Hanger
When you have attached the Spanning Rails to the base of the Computer Module you are ready
to attach the Wall Hanger (M1180A # A26). The procedure to attach the Wall Hanger is detailed
in the following steps.
Step 1 Place the Computer Module on its rear so that the spanning rails are towards you.
Step 2 Align the four holes in the Wall Hanger with those in the spanning rails.
Step 3 Holding the Wall .Hanger with one hand, insert the four screws finger tight with
the other hand.
Step 4 Holding the Uppermost (front) of the Computer Module with one hand tighten the
screws with the other.
Step 5
Step 6
Lay the Computer Module flat with the Wall Hanger uppermost and the front
towards you.
Lift the Computer Module and hook the Wall Hanger over the Mounting Arm.
Secure in position with the large Locking Screw on the left of the Wall Hanger
hook.
6-27