HP M2350A Service Manual page 193

To Connect the 21-&h Remote Display
a
Connecting the Display Directly to the Function Box
Installing the System
Installing the Components
connect6.gal
1. Connect the 15-pin Male connector of the 1.5m signal cable to the video connector on the
rear of the display.
2.
Connect
the other end of the signal cable to the l&pin Female connector on the adapter
cable..
3. Connect the 9-pin Male connector at the other end of adapter cable to the rear of the
function box.
4. Connect the AC power cord to the rear of the display.
5. Plug the power cord into the isolation transformer, or wall power outlet.
When the D2800 Display is used in the patient area or driven by video
from a function box in the patient area, power must be supplied by one of
the following isolation transformers: HP M1247A Isolation Transformer
(110 V) or HP M1964A Isolation Transformer (220 V).
6. If used, connect the isolation transformer power cord to the wall power outlet.
7. Switch the monitoring instrument on, then the display. See the user's guide for the display
for a display performance assurance test.
Connecting the 21-inch Display less than 25m from the Function Box
Wall
Cable M1181-61666 or
Cable M1181-61667
1 E-pin DM
E-pin DM 15-pin DF
connect4.gal
7-19