'lb Remove the Locking
Cam
Removing and Replacing Components
Servicing the Display Module
The procedure for removing the locking cam is described in the following steps.
Step 1
Lay the Display Module face-down on a soft surface, such as foam or cardboard.
Step 2
Remove the single mounting screw, on the locking cam, using a No.1 cross-tipped
screwdriver.
'lb Replace the Locking
Cam
The procedure for replacing the locking cam is described in the following steps.
Step 1
Lay the Display Module face-down on a soft surface, such as foam or cardboard.
Step 2
Locate the Locking Cam over the hole, in the base of the Display Module, so it
points towards the rear of the unit.
Step 3
Replace the single mounting screw, on the locking cam, using a No.1 cross-tipped
screwdriver.
12-25