To Remove The Rear/Cable Cover - HP M2350A Service Manual

Removing and Replacing Components
Servicing the Display Module
To Remove the Rear/Cable Cover
The procedure for removing the rear/cable cover is described in the following steps.
Step 1
Slide the two sprung locks towards the center of the cover and lift the lower edge
of the cover.
Step 2
Step 3
Raise the cover so it is horizontal and slide the cover directly out on the rear of
the display.
Lean the cover against
the
side of the display such
that
you can see the ground
connection to the case
Step 4
Using a cross-tipped screwdriver, remove the large
grounding
screw from the
inside of the display's left panel. Make sure that you retain the two washers.
To Replace
the Bear/Cable Cover
The procedure for replacing the rear/cable cover is described in the following steps.
Step 1
Lean the cover against the rear of the display such that you can connect the
ground wire to the case of the display.
Step 2
Using a cross-tipped screwdriver, replace the large grounding screw on the inside
of the display's left panel. Make sure that you replace the two washers either side
of the cable eyelet.
Step 3 Holding the cover horizontally, slide the cover in to the top of the display and
lower the free edge of the cover to
the
vertical
Step 4 Push the bottom of the cover firmly into place and the two sprung locks click to
lock the cover into place.
12-l