HP M2350A Service Manual page 294

Removing
and Replacing Components
Servicing the Display
Module
To Replace the Switch-Mode Power Supply
(M1092A/M1094A)
The procedure for replacing the switch-mode power supply (SMPS) is described in the following
steps.
, ,
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Hold the SMPS with the E-pin D-type connector toward you and the open part of
the SMPS case to the left.
Place the SMPS into the display module, so that you can make the connection on
the far side of the SMPS.
Replace the connector simply by pushing into the receptacle on the far side of the
SMPS.
Locate the SMPS into the display such that the holes in both the SMPS and the left
panel of the display are aligned.
Using a cross-tipped screwdriver, replace the two screws from the outside of the
display's left panel. These screws secure the SMPS to the display module.
Replace the black wires for the plug-in spade terminals on the SMPS cover.
Replace the power connector (orange and black wires) for the deflector board on
the top of the SMPS; replace the power connector (red and black wires) for the
human interface on the top of the SMPS.
Figure
12-11. Switch-Mode Power Supply (M1092A/M1094A)
12-22