HP M2350A Service Manual page 276

Removing and Replacing Components
Servicing the Display Module
Removal Flow Diagrams: Display Module
These flow diagrams (two for the color displays and one for the monochrome) illustrate the
order in which you must disassemble the display module. You must first locate the item you
wish to remove and then ALWAYS work from the START box at the top of the diagram and
follow the flow until you reach the desired item and the STOP. For example, if you wish to
remove the metal cover from the M1092A/M1094A, you must follow the path for removing the
line filter and the plastic cover and then stop at the switch-mode power supply box.
You
MUST
perform all the disassembly tasks in this section in the order shown by the diagram.
Where paths are divided this means the disassembly procedures can be performed in any order.
Alternatively, where paths re-join this means that all the above procedures must be performed
before you can move further down the flow chart.
CST;RT )
IS DISPLAY MOUNTED
ON THE COMPUTER
MODULE ?
HAS THE POWER
BEEN SWITCHED
OFF > 10 MINS ?
7
REMOVE
REAR
COVER
I
I r
I
REMOVE REMOVE REMOVE
REMOVE
REMOVE
POWER POWER PLASTIC PLASTIC LOCKING
FUSES FILTER COVER
BEZEL
CAM
I
I
REMOVE REMOVE REMOVE
REMOVE
POWER FAIL
METAL HUMAN INTEGRAL
RELAY
COVER INTERFACE KEYPAD
Figure 12-1. Removal Flow Diagram - Ml0944 Color Display Module
124