Removing
and
Replacing Components
Servicing the Display Module
'lb Remove the Power Fases
The procedure for removing the power fuses is described in the following steps.
Step 1
Using a flat-tipped screwdriver, turn the fuse cap a quarter- turn
counter-clockwise. The fuse cap should spring slightly from the rear of the display.
Step 2
Pull the fuse cap and fuse clear of the. display.
Step 3
Pull the fuse out of the fuse cap and note the fuse's rating.
Step 4
Repeat steps 1 to 3 for the other fuse.
To Replace the Power Fuses
The procedure for replacing the power fuses is described in the following steps.
Step 1
Step 2
Step 3
Step 4
Step 5
Locate one end of the fuse, of the correct value, into the fuse cap.
Locate the fuse and fuse cap into the receptacle in the rear of the display.
Using a flat-tipped screwdriver, gently push the fuse cap into the display.
Hold the fuse cap into the display turn the fuse cap a quarter-turn clockwise and
withdraw the screwdriver. The fuse cap should remain in the body of the display.
If not repeat steps 3 and 4.
Repeat steps 1 to 4 for the other fuse.
12-8