HP M2350A Service Manual page 170

Mounting the Components
Installing A-Option Mounts
To InstaU the Ceiling Mount
The Ceiling Mount (M1180A # AlO, # All or # A12) can be used to mount either the 14"
Display Module or the 14" Display Module and Computer Module combined. The procedure for
Ceiling-mounting any equipment is detailed in the following steps.
Notes
I
Ii?
1. The ceiling flange, down-pipe and anti-swing bracing guys should already be
fitted by the customer, prior to carrying out the following procedures.
2. If mounting a 14" Display Module or 14" Display Module and Computer
Module combined, spanning rails must be fitted to the base of the
equipment, as described earlier in this chapter.
4.25' BEARING SURFACE
3.61 BOLT URCLE (4)
SWIVEL BEARING
TORSION CLUTCH
XAMPLE OF HDLE PATTERN FOR
STOM FIT TO THREADED INSERTS
Figure 6-26. FiP Ceiling Mount