HP M2350A Service Manual page 283

Removing and Replacing Components
Servicing the Display Module
'lb Remove the Plastic Cover
The procedure for removing the plastic cover is described in the following steps.
Step 1 Using the cross-tipped screwdriver, remove the two screws securing the cover to
the display rear panel.
Step 2
Grip the sides of the cover and slide it towards the rear of the display module until
it stops.
Step 3 Grip inside the lower edges of each side of the cover and spring them outward and
lift the cover clear of the display module.
'lb Replace the Plastic Cover
The procedure for replacing the plastic cover is described in the following steps.
Step 1
Grip inside the lower edges of each side of the cover, with the back towards you,
and spring them outward.
Step 2
Lower the cover over the top of the display module so that it is an inch away from
the front bezel.
Step 3
Step 4
Grip the sides of the cover and slide it towards the front of the display module
until it clicks into place.
Using the cross-tipped screwdriver, replace the two screws securing the cover to
the display rear panel.
Figure 12-5. Plastic Cover
12-11