Metal Cover (M1092A/M1094A) - HP M2350A Service Manual

Removing and Replacing Components
Servicing the Display Module
'lb Replace
the
Metal Cover (M1092AN1094A)
The procedure for replacing the metal cover is described in the following steps. All screws are
replaced using a cross-point screwdriver.
Step 1
Using one hand, support the cover near to the rear of the display and pass the
connectors to the line filter through the holes. The three connectors from the
mains inlet connector are passed through the left hole
and
the two load connectors
to the SMPS are passed through the right hole.
Step 2
Only if display is color, locate the cover on the display so that the holes in both the
cover and the display are aligned.
Step 3
Replace the eight screws that secure the cover to the display. There are six screws
on the top of the cover and one on each of the display's outside side panels.
Figure 12-8. Metal Cover (M1092A/M1094A)
12-17