HP M2350A Service Manual page 168

Mounting the Components
Installing A-Option Mounts
Spanning
Spring
M4 x Fmn PHMS
M4 x fm PHMS
L, Adaptor Plate into
Spanning Rail
1, Plunger Clearance Uole
Adaptor Plate
Wall Channel
~~
l&T
7 ftounting Plate
/
1sh"pport Arm
\
Diagonal Brace
Slide with
%Ion stop Screl
Figure 6-24. Tilt and swivel wall mount structure
Insert the Support Arm/Mounting Plate Assembly in the Wall Channel and adjust to
,fl
Step 1
the desired height.
Warning Ensure that the Support Arm is correctly placed in the Wall Channel and
-9
that both the Movable Stop and the Fixed Stop are fitted to the channel.
This prevents the Mounting Arm from falling out of the bottom of the I&l1
Channel when the equipment is attached.
Step 2
Step 3
Step 4
Step 5
Step' 6
Install the diagonal brace.
Back off the nylon jack screws in the mounting plate and slide the equipment and
adapter plate sideways into the mounting plate.
Pull down on the spring plunger to clear the edge of the adapter plate and release
to engage in the clearance hole.
Tighten the nylon jack screws to secure the adapter plate in place.
Firmly secure the mounting plate to the adapter plate with two screws (not shown
on diagram).
6.26