HP M2350A Service Manual page 212

Configuring the System
Configuration Mode
Entering ConfQuration Mode
fl
To start configuring the system, you must select Configuration Mode. To select Configuration
Mode, use the procedure detailed in the following steps.
Step 1
Step 2
b?.SS Monitor Setu .
e) The instrument configuration selection is displayed.
. ;. :.......L; :
Press :op~r~~~~~~'~~~~~~~. The Operating Mode task window dispIays the current
.>. ..s. ,,,. :,r..: ,. .::..:. . . . . . . . . . . .
operating mode in words (for example, "Operating Mode - Monitoring") and
prompts for a password.
Step 3
Step 4
Enter the configuration password, a four digit number, using i-k: to 'i$:.
Password = 1245
.~ _
il...
If the password is entered correctly, then Cl&&j$&:lP~ode.'- is highlighted. If the
password is entered incorrectly the system remains in the Operating Mode task
window.
Step 5
Step 6
Step 7
Press ~~~~~~~~,~~~~~~: The Operating Mode task window displays ~,~~~~~.~~; and
$o.#%$ in reverse video with the current operating mode highlighted.
i ,. " " _L.
.;:.. ., . ..'.,-y..yy :; /,, .,.i. . . . ..,. ~.
Highlight the Config mode by using the arrow keys or pressing ;'Clili~e;. Qpjiiodoi'.
.,.,.,,,,,. ~, /T.. : : .;'.; c
Press (-1 to switch to the highlighted mode. The system now performs a
cold-start and the mode is switched from Monitoring Mode to Configuration Mode.
Note
I
lb
When Configuration Mode is entered, the display becomes blank and the
message "Config mode active - NO MONITORING!' appears at the top of the
screen. Press
&.trument Config)
to display the Instrument Configuration Window.
CS number
:I
Start bed range:?
End bed range :24
Care Unit
:Yes
SCC connected:Yes
Printer
:DeskJet
Alam tone vol
:VerYSoft
Silence alams :No
Bed to sector :Yes
I
General Config
Color scheme
:Standard
Screen notes :Location
Alam recording
:All R+Y
Delayed Record :I Wave
2-than delayed
2 Chan
2-than realtime :2 Chan
Frhom oloqation
:No
Fl F2
F3
F4
F5
Figure S-l. Monitor Setup Window
F7
ptconfig.gal
8-2