Suzuki XL7 2007 Service Manual page 1518

5A-108 Automatic Transmission:
Scan Tool Output
Control
Shift Trans.
Trans. Adaptives Reset —
Trans. Oil Life Reset
Scan Tool Output Controls - Shift Lock Control
Scan Tool Output
Control
Shift Lock Solenoid
Additional Menu
Selections
• The TCM commands upshifts and downshifts. The scan tool
• When the ignition is ON, and the engine is OFF, there are no
• When the engine is running, the following control limits apply:
—
• The TCM clears, or resets, all TAP cells to zero.
• There are no limits to using this control. It may be performed with
• The TCM resets the amount of transmission oil life remaining to a
—
• There are no limits to using this control. It may be performed with
Additional Menu
Selection(s)
Special Functions,
BCM, Miscellaneous Command supplies battery voltage to the A/T shift lock control
Test circuit ON or OFF for 5 seconds.
Commanded Gear parameter should match the commanded
state.
limits to this control. The scan tool shift solenoid states change to
match the Commanded Gear selected.
– The TCM does not allow a shift if it will cause the engine RPM
to exceed a calibrated limit. If a gear is requested and the
engine speed is too high, the message "Engine speed to high"
appears on the scan tool display.
– The TCM does not allow a 3-2 or 2-1 downshift if the vehicle
speed exceeds a calibrated limit. If either downshift is
requested and the vehicle speed is too high, the message
"Eng. is on and veh. speed too hi for 3-2 or 2-1 downshift"
appears on the scan tool display.
– The TCM does not allow a 4-3 downshift if the vehicle speed
exceeds a calibrated limit. If a 4-3 downshift is requested and
the vehicle speed is too high, the message "Vehicle speed too
high" appears on the scan tool display.
– The TCM does not allow an upshift if the vehicle speed
exceeds a calibrated limit. If an upshift is requested and the
vehicle speed is too high, the message "Vehicle speed too
high" appears on the scan tool display.
the engine running or when the ignition is ON, and the engine is
OFF.
value selected.
the engine running or when the ignition is ON, and the engine is
OFF.
Description
Description