Table of Contents
Advertisement
5A-226 Automatic Transmission:
3. Install the transaxle oil cooler line assembly nut (2).
Tightening torque
Tighten the transaxle oil cooler lines to 9 N⋅m (80
lb in).
4. Connect the lower transaxle oil cooler line to the
radiator.
5. Engage the transaxle oil cooler lines with the fan
shroud by snapping in place.
6. Lower the vehicle.
7. Connect the upper transaxle oil cooler line to the
radiator.
NOTE
DEXRON III automatic transmission fluid is
not compatible with this transaxle. If
DEXRON III ATF is used, transaxle failure will
result. This transaxle uses GM T-IV fluid P/N
88900925.
8. Add fluid to the transaxle. Refer to the "Transmission
Fluid Check".
9. Start the engine a check for leaks.
Fluid Cooler Pipe Seal Replacement
Special tool
J 41239-1A Cooler Line Seal Installer
J 45201 Cooler Line Seal Remover
Removal Procedure
1. Raise Vehicle. Refer to "Lifting and Jacking the
Vehicle: " in General Information.
WARNING
!
Ensure that the vehicle is properly supported
and squarely positioned. To help avoid
personal injury when a vehicle is on a hoist,
provide additional support for the vehicle on
the opposite end from which the components
are being removed.
2. Place a drain pan or suitable container under the
vehicle.
3. Remove the transaxle oil cooler line assembly nut
from the transaxle.
4. Disconnect the transaxle oil cooler lines from the
vehicle.
Advertisement
Table of Contents
Troubleshooting
