Table of Contents
Advertisement
Oil Cooler Line Replacement
Removal Procedure
WARNING
!
Ensure that the vehicle is properly supported
and squarely positioned. To help avoid
personal injury when a vehicle is on a hoist,
provide additional support for the vehicle on
the opposite end from which the components
are being removed.
1. Position the vehicle on a hoist and raise the hood.
2. Place a drain pan or suitable container under the
vehicle.
3. Disconnect the upper transaxle oil cooler line from
the radiator.
4. Raise the vehicle. Refer to "Lifting and Jacking the
Vehicle: ".
5. Disconnect the lower transaxle oil cooler line.
6. Disengage the transaxle cooler lines from the fan
shroud.
Automatic Transmission:
7. Remove the transaxle cooler line assembly nut (2)
from the transaxle.
8. Remove the transaxle cooler lines (1) from the
vehicle.
9. Replace the transaxle oil cooler pipe seals. Refer to
the "Fluid Cooler Pipe Seal Replacement".
Installation Procedure
1. Install the transaxle oil cooler lines into the vehicle.
2. Install the transaxle oil cooler line assembly (1) to the
transaxle.
CAUTION
!
Refer to "Fastener Notice: ".
5A-225
Advertisement
Table of Contents
Troubleshooting
