Table of Contents
Advertisement
5A-228 Automatic Transmission:
3. Install the nub of the J 41239-1A on the transaxle
cooler line seal.
4. Tap the new transaxle cooler line seal into the case
bore.
5. Install the transaxle oil cooler line assembly to the
transaxle.
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
6. Install the transaxle oil cooler line assembly nut.
Tightening torque
Tighten the transaxle cooler line retaining nut to
7 N⋅m (62 lb in).
7. Lower the vehicle.
NOTE
Dexron III automatic transmission fluid is not
compatible with this transaxle. If Dexron III
ATF is used, transaxle failure will result. This
transaxle uses GM T-IV fluid P/N 88900925.
8. Add fluid to the transaxle. Refer to "Transmission
Fluid Check" procedure located in this service
manual.
9. Start the engine and check for leaks.
Drive Axle Shaft Seal Replacement (Left)
Special tool
J 44809 Output Shaft Seal Installer
J 45000 Seal Remover
Removal Procedure
1. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
2. Place a drain pan under the transaxle to catch any
spilled transaxle fluid.
3. Remove the left front axle shaft. Refer to "Front
Wheel Drive Shaft Replacement (AWD): " "Front
Wheel Drive Shaft Replacement (FWD): ".
4. Using the J 45000, remove the axle seal from the
transaxle and discard.
5. Clean the seal bore in the transaxle housing.
Advertisement
Table of Contents
Troubleshooting
