Suzuki XL7 2007 Service Manual page 1619

1. Using an adjustable wrench on the manual shaft
detent lever (710), turn the shaft clockwise until it
stops.
2. Turn the shaft counterclockwise one position to the
neutral location. To verify turning the shaft in the
correct direction, on the manual shaft detent lever
(710) the reverse position is larger and more
resistance can be felt.
3. Inspect the condition of the connector pins on the
wiring harness assembly (33) for foreign material,
bent pins, or broken pins.
4. Ensure the TCM seal (72) is installed.
5. Turn the slot in the TCM to align the 2 marks. Do not
turn more than 60 degrees.
Automatic Transmission:
6. Install the TCM (4) over the manual shaft.
CAUTION
!
Refer to "Fastener Notice: ".
7. Install the bolts (3).
Tightening torque
Tighten the bolts to 25 N⋅m (18 lb ft).
8. Connect the electrical connectors (3, 5) to the TCM.
9. Install the manual shaft detent lever. Refer to
"Automatic Transmission Range Selector Lever
Replacement".
10. Install the battery tray. Refer to "Battery Tray
Replacement: ".
NOTE
DTC P0602 is set with all new service
transaxle control modules. When the
transaxle control module is reprogrammed
with the correct software and calibrations,
DTC P0602 will be erased.
11. Reprogram the TCM with the correct calibration.
Refer to "Control Module References: ".
12. Perform the transmission adaptive learn procedure.
Refer to "Transmission Adaptive Learn and
Transmission Neutral Learn".
5A-209