Suzuki XL7 2007 Service Manual page 1659

31. Inspect the bushing for scoring or excessive wear.
32. Using J 45185 and a micrometer measure the rear
sun gear bushing inner diameter (A). Measure in
three locations and take the average.
Specification
Rear sun gear bushing: 22.200-22.276 mm (0.874-
0.877 in)
Front Internal Gear and Low and Reverse
Clutch Assembly Removal
Reference: "Rear Internal Gear and Front Carrier
Removal".
Special tool
J 28585 Snap Ring Remover
1. Remove the front internal gear thrust bearing (529).
Automatic Transmission:
2. Remove the low and reverse clutch plate retaining
ring (518) from the transmission case assembly with
J 28585.
3. Remove the low and reverse clutch backing plate
(520).
4. Remove the 5 low and reverse clutch fiber plate
assemblies (516).
5. Remove the 4 low and reverse clutch steel plates
(517).
6. Remove the low and reverse clutch apply plate
(515).
5A-249