Table of Contents
Advertisement
5A-288 Automatic Transmission:
3. Inspect the anchor bolt and the bolt hole.
4. Apply automatic transmission fluid to a new O-ring
(65).
CAUTION
!
Refer to "Fastener Notice: ".
5. Install the new O-ring and third gear band anchor
bolt (64) using DT-47599.
Tightening torque
Tighten the anchor bolt to 167 N⋅m (123 lb ft).
6. Reinstall the holding fixture bolt (1) and tighten bolt
(2) for the holding fixture.
Reference: "4-5 Clutch Assembly Installation".
4-5 Clutch Assembly Installation
Reference: "4-5 Clutch Piston Travel Measurement".
Install the 4-5 clutch assembly (15) into the transmission
case assembly, making sure not to disengage the third
gear band assembly (16) from its holding points. When
properly installed, the 4-5 clutch assembly (15) should
spin freely by hand with no drag on the third gear band
assembly (16).
Reference: "Front Differential Transfer Drive Gear
Assembly Installation".
Front Differential Transfer Drive Gear
Assembly Installation
Special tool
J 45053 Universal Clamp Press
1. Inspect the front differential transfer drive gear
assembly rear bearing assembly, located in the
transmission case cover assembly, before installing
the front differential transfer drive gear assembly
(14) to be sure that all roller bearings are in the
correct position.
Advertisement
Table of Contents
Troubleshooting
