Suzuki XL7 2007 Service Manual page 1580

5A-170 Automatic Transmission:
Clean-up
1. Turn the main function switch to the IDLE position
and allow the supply vessel pressure to dissipate.
2. Turn the main power switch to the OFF position.
3. Disconnect the supply and waste hoses and the 12-
volt power source from the vehicle.
Note: A small amount of water may drain from the
bottom of the unit when the air supply is
disconnected. This is a normal operation of the built-
in water separator.
Transmission Overheats
Condition
DEFINITION: Transmission overheats
Low fluid level
Incorrect fluid
Fluid Filter (42) is restricted
Restricted Oil Cooler Lines
Internal oil cooler restriction
Case Assembly oil inlet filter/screen Remove the inlet cooler line seal from the case assembly. Inspect for foreign
4. Disconnect the air supply hose from J 45096.
5. Dispose of the waste ATF in accordance with all
6. Clean the residual DEXRON III from the
Inspect for leaks and repair as necessary.
Replace the fluid with the correct fluid
• Diagnose the cause for the filter restriction and repair as needed.
• Replace the fluid filter (42) and fluid.
• Inspect for bent or kinked pipes
• Inspect for pinched or kinked hoses
• Inspect for cracks or signs of hose overheating that may cause delamination
of the hose
• Replace faulty oil cooler lines
Replace radiator assembly and fluid.
material trapped by the case inlet filter/screen. Clean the passage to remove the
foreign material from the case inlet screen. If unable to remove the foreign
material, the screen will have to be removed from the case assembly and
cleared manually outside of the case assembly.
applicable federal, state, and local requirements.
transmission oil cooler, using compressed air to blow
out the transmission oil cooler.
Action