Suzuki XL7 2007 Service Manual page 1744

5A-334 Automatic Transmission:
7. Install a new control valve body fluid passage cover
gasket (38).
8. Install the control valve body fluid passage cover
(37).
9. Install the 2 - M6 x 1.0 x 50 mm control valve body
bolts.
Tightening torque
Tighten the control valve body bolts to 10 N⋅m
(89 lb in).
Reference: "Wiring Harness Installation".
Wiring Harness Installation
1. Install a NEW automatic transmission wiring
connector seal (46) in the bore for the connector.
The taper side of the seal goes up.
2. Install a NEW TCM seal (72) on the connector.
3. Install the transmission wiring harness assembly
(33) into the transmission case assembly through
the wiring harness bore.
4. Align the tab of the connector in the transmission
case.
5. Install the wiring harness connector retainer (69).
6. Apply automatic transmission fluid to the new
transmission fluid temperature sensor O-ring seal
(32).
7. Install the new transmission fluid temperature sensor
O-ring seal (32) into the groove of the transmission
fluid temperature sensor (36).
8. Install the transmission fluid temperature sensor (36)
into the front control valve body fluid temperature
sensor bore.
9. Install the transmission fluid temperature sensor clip
(49).
10. Install the 1 - M6 x 1.0 x 55 mm fluid temperature
sensor bolt (31).
Tightening torque
Tighten the fluid temperature sensor bolt to 10
N⋅m (89 lb in).