4. Install the clutch field coil connector bracket screw to
the compressor.
Tightening torque
Tighten the screws to 3 N⋅m (27 lb in).
5. Using GE-47851, install the compressor pulley to the
compressor.
Heating, Ventilation and Air Conditioning:
NOTE
Ensure that the compressor pulley snap ring
is installed with the rounded edge face up.
6. Install the snap ring to the compressor pulley.
7. Install the compressor clutch shims to the
compressor shaft.
8. Align the compressor clutch with the compressor
shaft and install to the compressor.
9. Using GE-47851, install the compressor clutch to the
compressor.
7A-91