Suzuki XL7 2007 Service Manual page 1719

3. While holding the second coast clutch hub and sprag
assembly (11) together, install into the fluid pump
assembly.
4. Place a straight edge on top of the second clutch
sprag outer race thrust washer.
5. Measure the distance (b) from the bottom of the
straight edge and the fluid pump assembly.
Specification
Installed height: 51.09 - 51.71 mm (2.011 - 2.036
in)
6. If the installed height is greater than specifications,
the second coast clutch hub did not clear all the
second clutch fiber plates. Index again the clutch
hub and plates until within specifications.
Automatic Transmission:
7. Rotate the transmission assembly as shown.
8. Install the J 45053 on the fluid pump assembly.
– Do not allow the second clutch sprag assembly to
separate from the clutch plates.
– Back out the forcing screw of the J 45053 to
ensure, ample clearance of the input shaft.
9. Install the fluid pump assembly.
– Do not allow the input shaft splines to touch the
bushings in the fluid pump assembly.
– Align the holes of the fluid pump assembly to the
transmission case.
– Do not allow the second clutch sprag assembly to
separate from the clutch plates.
10. Lightly press the fluid pump body into the
transmission case assembly in order to seat the fluid
pump assembly in place.
5A-309