Suzuki XL7 2007 Service Manual page 1688

5A-278 Automatic Transmission:
1-2 Reverse Clutch Disassemble
Reference: "Case Cover and 1-2 Reverse Clutch
Assembly Removal".
Special tool
J 23327 Clutch Spring Compressor
J 28585 Snap Ring Remover
J 23456 Booster and Clutch Pack Compressor
J 45184 Differential Bearing Race Installer
1. Remove the 1-2 reverse clutch backing plate
retaining ring (622) using J 28585.
2. Remove the following components:
– The 1-2 reverse clutch backing plate (621)
– The 6 1-2 reverse clutch fiber plates (620)
– The 6 1-2 reverse clutch steel plates (619)
– The 1-2 reverse clutch apply plate (618)
NOTE
Do not bend the 1-2 reverse clutch piston
return spring assembly (601).
3. Place J 45184 (1) on the center of J 23456 (2).
4. Place the transmission case cover (19) with the 1-2
reverse clutch piston assembly onto J 45184 (1).
5. Using J 23327-1 (3), which is the bridge part of J
23327, compress the 1-2 reverse clutch piston return
spring assembly (601).
6. Remove the 1-2 reverse clutch piston return spring
retaining ring (600) using snap ring pliers.
7. Remove the pressure from J 23456 (2), remove J
23327-1 (3) and the 1-2 reverse clutch piston return
spring assembly (601).
8. Remove all tools.
WARNING
!
Wear safety glasses when using compressed
air in order to prevent eye injury.
9. While pulling upward on the piston by hand, apply
compressed air into the 1-2 reverse clutch fluid
passage and remove the 1-2 reverse clutch piston
(603).
10. Remove the 1-2 reverse clutch piston inner seal
(602).
11. Remove the 1-2 reverse clutch piston outer seal
(604).
Reference: "Case Cover Cleaning and Inspection".