Table of Contents
Advertisement
6. With the key on engine off, turn the steering wheel
fully to the left and to the right while an assistant
maintains the minimum fluid level in the reservoir
using new approved power steering fluid. Continue
until the fluid from the return hose runs clear.
7. Remove the plug from the pump reservoir inlet
connection and install the fluid return hose to the
pump reservoir.
Remote Power Steering Fluid Reservoir Replacement
Power Assisted Steering System:
NOTE
Do NOT run the engine without the power
steering fluid at a minimum system level.
8. Bleed the power steering system. Refer to "Power
Steering System Bleeding".
9. Inspect the power steering fluid for the following
indications of contamination:
– Milky fluid - water
– Brown fluid - burnt
– Plastic debris or dirt chunks
10. If the fluid is contaminated, repeat steps 2-9.
11. Lower the vehicle and check the Power Steering
system for leaks.
6C-11
Advertisement
Table of Contents
Troubleshooting
