Suzuki XL7 2007 Service Manual page 1920

7A-106 Heating, Ventilation and Air Conditioning:
Installation Procedure
1. Add the specified amount of PAG oil to the
condenser. Refer to "Refrigerant System
Capacities".
2. Inspect the radiator to condenser seals for the
proper position.
3. Install the condenser to the lower retention clips on
the radiator.
CAUTION
!
Refer to "Fastener Notice: ".
4. Install the bolts to retain the top of the condenser to
the radiator.
Tightening torque
Tighten the bolts to 9 N⋅m (80 lb in).
5. Install the CRFM brackets to the vehicle.
6. Install the CRFM bracket bolts to the radiator
support.
Tightening torque
Tighten the bolts to 20 N⋅m (15 lb ft).
7. Remove the protective cap from the compressor
hose.
8. Install a new sealing washer to the compressor
hose. Refer to "Sealing Washer Replacement".
9. Install the compressor hose to the condenser.
10. Install compressor hose nut to the condenser.
Tightening torque
Tighten the bolts to 20 N⋅m (15 lb ft).
11. Install a new seal washer to the liquid line. Refer to
"Sealing Washer Replacement".
12. Install the liquid line to the condenser.
13. Install the liquid line nut to the condenser.
Tightening torque
Tighten the bolts to 20 N⋅m (15 lb ft).