Table of Contents
Advertisement
12. Inspect the fluid pump gears for rotating smoothly.
a. Install the fluid pump assembly on the torque
converter.
b. Rotate the body of the fluid pump assembly.
c. Ensure the fluid pump seal was not damaged.
Reference: "Second Clutch Assemble".
Second Clutch Assemble
Reference: "Transmission Fluid Pump Assemble".
Special tool
J 28585 Snap Ring Remover
NOTE
Soak the new clutch plates in automatic
transmission fluid for at least 2 hours before
replacing them.
Automatic Transmission:
1. Inspect that the sliding surface of the clutch plates
are not worn or burnt. If the clutch plates are worn or
burnt, replace them.
2. Apply automatic transmission fluid to the new
second clutch piston and second clutch piston
sleeve seals.
3. Install the new second clutch piston outer seal (209)
onto the second clutch piston (210).
4. Install the new second clutch piston sleeve seals
(211, 213) onto the second clutch piston sleeve
(212).
5. Apply automatic transmission fluid to the inner
surfaces of the fluid pump stator shaft assembly.
6. Press the second clutch piston (210) and the second
clutch piston sleeve (212) into the fluid pump stator
shaft assembly.
7. Install the second clutch spring assembly retaining
ring (214).
8. Install the second clutch spring assembly (215) onto
the second clutch piston with the spring side up.
5A-303
Advertisement
Table of Contents
Troubleshooting
