Suzuki XL7 2007 Service Manual page 1639

Installation Procedure
1. Using the J 44809, install the left axle seal into the
transaxle.
2. Install the left front axle shaft. Refer to "Front Wheel
Drive Shaft Replacement (AWD): " "Front Wheel
Drive Shaft Replacement (FWD): ".
3. Lower the vehicle.
NOTE
Dextron®III automatic transmission fluid is
not compatible with this transaxle. If
Dextron®III ATF is used, transaxle failure will
result. This transaxle uses GM T-IV fluid GM
P/N 88900925.
4. Inspect the transaxle fluid level. Refer to
"Transmission Fluid Check".
Drive Axle Shaft Seal Replacement (Right)
Special tool
J 45000 Seal Remover
DT-48392 Differential Oil Seal Installer
J 8092 Driver Handle
Removal Procedure
1. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
2. Place a drain pan under the transaxle to catch any
spilled transaxle fluid.
3. Remove the right front wheel drive shaft. Refer to
"Front Wheel Drive Shaft Replacement (AWD): "
"Front Wheel Drive Shaft Replacement (FWD): ".
4. If equipped with an axle seal dust cover, discard it
and do not replace it.
Automatic Transmission:
5. Using the J 45000 remove the right drive axle seal
from the transaxle.
6. Clean the seal bore in the transaxle housing.
Installation Procedure
1. Using the DT-48392 with J 8092, install the right
drive axle seal onto the transaxle.
2. Install the right front wheel drive shaft. Refer to
"Front Wheel Drive Shaft Replacement (AWD): "
"Front Wheel Drive Shaft Replacement (FWD): ".
3. Lower the vehicle.
NOTE
Dextron®III automatic transmission fluid is
not compatible with this transaxle. If
Dextron®III ATF is used, transaxle failure will
result. This transaxle uses GM T-IV fluid GM
P/N 88900925.
4. Inspect the transaxle fluid level. Refer to
"Transmission Fluid Check".
5A-229