Table of Contents
Advertisement
Stabilizer Shaft Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
NOTE
In the following service procedure, it is not
necessary to remove the rear suspension
support. Lower the support enough to
remove the stabilizer bar.
2. Lower the rear suspension support. Refer to
"Support Replacement (AWD Vehicles)" "Support
Replacement (FWD Vehicles)".
3. Remove the spare tire from the vehicle.
NOTE
Hold the ball shaft secure with a TORX® bit,
when removing the nut.
4. Remove the stabilizer link to stabilizer shaft nut.
5. Remove the stabilizer shaft clamp bolts.
6. Remove the stabilizer shaft clamps and bushings
from the stabilizer shaft.
7. Disengage the stabilizer shaft from the stabilizer link
ball studs, while removing the stabilizer shaft from
the vehicle.
Installation Procedure
1. Position the stabilizer shaft in the vehicle, while
positioning the links to the stabilizer bar.
2. Install the stabilizer shaft clamps and bushings to the
stabilizer shaft.
CAUTION
!
Refer to "Fastener Notice: ".
3. Install the stabilizer shaft clamp bolts.
Tightening torque
Tighten the bolts to 70 N⋅m (52 lb ft).
Rear Suspension:
2C-10
Advertisement
Table of Contents
Troubleshooting
