Suzuki XL7 2007 Service Manual page 1709

6. Remove the second clutch spring assembly retaining
ring (214).
WARNING
!
Wear safety glasses when using compressed
air in order to prevent eye injury.
7. While pulling on the piston by hand, apply
compressed air into the fluid passage and remove
the second clutch piston (210) and the second clutch
piston sleeve (212).
8. Remove the second clutch piston outer seal (209)
from the second clutch piston (210).
9. Remove the second clutch piston sleeve seals (211,
213) from the second clutch piston sleeve (212).
Reference: "Transmission Fluid Pump Disassemble".
Transmission Fluid Pump Disassemble
Reference: "Second Clutch Disassemble".
Special tool
J 45000 Seal Remover
Automatic Transmission:
1. Remove 13 transmission fluid pump cover bolts
(231) and 1 transmission fluid pump cover bolt (232)
to separate the fluid pump body from the fluid pump
stator shaft assembly (208).
2. Remove the fluid pump plate (207) from the fluid
pump body (202).
3. Remove the fluid pump O-ring seal (206) from the
fluid pump body (202).
4. Push the fluid pump driven gear (204) to one side of
the fluid pump body (202). Using a feeler gage,
measure the clearance between the fluid pump
driven gear (204) and the fluid pump body (202).
Specification
Driven gear to body clearance: 0.075 - 0.20 mm
(0.002 - 0.007 in)
5A-299