5A-220 Automatic Transmission:
CAUTION
!
Refer to "Fastener Notice: ".
5. Tighten the control valve body cover bolts in the
sequence shown.
Tightening torque
Tighten the bolts to 13 N⋅m (115 lb in).
6. Install the transaxle oil cooler lines and seals to the
transaxle. Refer to "Fluid Cooler Pipe Seal
Replacement".
7. Install the front engine mount. Refer to
"Transmission Front Mount Replacement".
8. Install the left and right splash shield. Refer to
"Engine Splash Shield Replacement - Left Side: "
and "Engine Splash Shield Replacement - Right
Side: ".
9. Install the left front wheel and the tire assembly.
Refer to "Tire and Wheel Removal and Installation: ".
10. Lower the vehicle.
11. Check the transaxle fluid level. Refer to
"Transmission Fluid Check".
Automatic Transmission Wiring Harness
Replacement
Removal Procedure
1. Remove the control valve body cover. Refer to
"Control Valve Body Cover Replacement".
2. Disconnect the wiring harness connectors (1-8).
3. Remove the fluid temperature sensor bolt (31).
4. Remove the fluid temperature sensor clamp (49).
5. Remove the fluid temperature sensor (36) and the
O-ring (32) from the control valve body.