Table of Contents
Advertisement
5A-242 Automatic Transmission:
Front Differential Transfer Drive Gear
Assembly Removal
Reference: "Manual Shift Detent Lever and Park Pawl
Removal".
Special tool
J 45053 Universal Clamp Press
1. Remove the front differential transfer drive gear
thrust bearing assembly (263) from the front
differential transfer drive gear assembly (14).
2. Remove the front differential transfer drive gear
thrust bearing washer (264) from the front differential
transfer drive gear assembly (14).
NOTE
The 4-5 clutch assembly may come out with
the front differential transfer drive gear
assembly. Do not let the front differential
transfer drive gear assembly or the 4-5 clutch
assembly fall to the floor or damage may
occur.
3. Using J 45053, remove the front differential transfer
drive gear assembly (14) from the transmission case
assembly.
Third Gear Band Servo Piston Pin
Measurement
Reference: "Front Differential Transfer Drive Gear
Assembly Removal".
1. Mark the servo piston pin in the released position
(1).
WARNING
!
Wear safety glasses when using compressed
air in order to prevent eye injury.
2. Apply compressed air to the servo apply passage
(3), and mark the apply position on the piston pin (2).
3. Measure the distance between the release and apply
marks (a). Refer to "Third Gear Band Servo Piston
Pin Selection" to select the correct servo piston pin.
Advertisement
Table of Contents
Troubleshooting
