5A-290 Automatic Transmission:
10. Install again the front differential drive gear (14), the
thrust washer and the thrust bearing.
11. Measure the thrust bearing height (a) again to make
sure it is in the specifications. If not within the
specifications, adjust the height by changing the
thrust washer.
Reference: "Manual Shift Detent Lever and Park Pawl
Installation".
Manual Shift Detent Lever and Park Pawl
Installation
1. Install the park pawl pin spring (704).
2. Install the park pawl pin spring guide sleeve (705).
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
3. Install the park pawl bolt/screw (706).
Tightening torque
Tighten the park pawl bolt to 10 N⋅m (89 lb in).
4. Install the park pawl spring pin (703).