Table of Contents
Advertisement
Installation Procedure
1. Position the power steering pump to the vehicle
through the right wheel house area.
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the power steering pump bolts (1).
Tightening torque
Tighten to 50 N⋅m (37 lb ft).
3. Connect the power steering gear inlet hose (1) to the
power steering pump.
Tightening torque
Tighten to 25 N⋅m (18 lb ft).
Power Assisted Steering System:
4. Compress the power steering reservoir outlet hose
clamp (1) and connect the power steering reservoir
outlet hose (2) to the power steering pump.
5. Install the right side engine splash shield. Refer to
"Engine Splash Shield Replacement - Right Side: ".
6. Clean any excess fluid from the vehicle.
7. Install the drive belt. Refer to "Drive Belt
Replacement: ".
8. Fill and bleed the power steering system. Refer to
"Power Steering System Bleeding".
6C-15
Advertisement
Table of Contents
Troubleshooting
