5A-336 Automatic Transmission:
Transmission Control Module Installation
1. Using an adjustable wrench on the manual shaft
detent lever (710), turn the shaft clockwise until it
stops.
2. Turn the shaft counter-clockwise one position to the
neutral location. To verify turning the shaft in the
correct direction, on the manual shaft detent lever
(710) the reverse position is larger and more
resistance can be felt.
3. Inspect the condition of the connector pins on the
wiring harness assembly (33) for foreign material,
bent pins, or broken pins.
4. Ensure the TCM seal (72) is installed.
5. Turn the slot in the TCM to align the two marks. Do
not turn more than 60 degrees.
6. Install the TCM (75) over the manual shaft detent
lever (710) and into the wire connector.
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
7. Install the three bolts (76).
Tightening torque
Tighten the TCM bolts to 25 N⋅m (18 lb ft).
Reference: "Input and Output Speed Sensor
Installation".