Suzuki XL7 2007 Service Manual page 1579

Hide thumbs Also See for XL7 2007:

Table of Contents

If the flow rate is less than 0.5 gpm, the LCD

displays an error message. Refer to the

Troubleshooting section of the operation

1. Turn the main function switch to the FLOW position

and allow the oil to flow for 15 seconds. Observe and

note the flow rate; this is the TESTED flow rate.

2. Compare the TESTED flow rate to the MINIMUM

flow rate information previously recorded.

– If the TESTED flow rate is equal to or greater than

the MINIMUM flow rate recorded, the oil cooling

system is functioning properly. Perform Code

Recording Procedure.

– If the TESTED flow rate is less than the MINIMUM

flow rate previously recorded, repeat the back

flush and forward flush procedures.

3. If the TESTED flow rate is less than the MINIMUM

flow rate after the second test, perform Code

Recording Procedure.

a. Replace the transmission oil cooler.

b. Reconnect supply and waste hoses to the cooler

lines in the normal flow direction. Perform Flow

c. Perform Code Recording Procedure.

Automatic Transmission:

Code Recording Procedure

1. Turn the main function switch to the CODE position.

• If power is interrupted prior to the

recording of the seven-character code, the

code will be lost and the flow rate test will

need to be repeated.

• The flow test must run for a minimum of 8-

10 seconds and be above 0.5 gpm for a

code to be generated.

2. Record TESTED flow rate, temperature, cycle and

seven-character flow code information on repair

Troubleshooting