Suzuki XL7 2007 Service Manual page 1712

5A-302 Automatic Transmission:
3. Apply automatic transmission fluid to the surface of
the fluid pump body.
NOTE
The index mark (dot) on the fluid pump drive
gear (205) is installed down, (see insert). The
index mark (dot) on the fluid pump driven
gear (204) is installed up.
4. Install the fluid pump drive gear (205) and the fluid
pump driven gear (204) to the fluid pump body (202).
5. Apply automatic transmission fluid to the new fluid
pump O-ring seal (206).
6. Install the new fluid pump O-ring seal (206) onto the
fluid pump body (202).
NOTE
Be sure to align the holes properly when
installing the fluid pump plate (207).
7. Align the fluid pump plate (207) holes with the
alignment pins (203) in the fluid pump body (202).
8. Align the fluid pump stator shaft assembly (208) with
each bolt hole of the fluid pump plate (207).
9. Install, and hand tighten, 12 of the 13 - M6 x 1.0 x
14.5 mm fluid pump cover bolts (231) and 1 - M5 x
0.8 x 17 mm fluid pump cover bolt (232).
10. Leave out the remaining M6 x 1.0 x 14.5 mm fluid
pump cover bolt (231) from the hole indicated by the
arrow in the graphic. Set the bolt aside to be installed
later.
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
11. Tighten the fluid pump cover bolts in sequence.
Tightening torque
• Tighten the 12 - M6 x 1.0 x 14.5 mm fluid pump
cover bolts (231) to 12 N⋅m (106 lb in).
• Tighten the 1 - M5 x 0.8 x 17 mm fluid pump
cover bolt (232) to 7 N⋅m (62 lb in).