Suzuki XL7 2007 Service Manual page 1690

5A-280 Automatic Transmission:
NOTE
Do not bend the 1-2 reverse clutch piston
return spring assembly (601).
5. Place the 1-2 reverse clutch piston return spring
assembly (601) on the 1-2 reverse clutch piston
(603), indexing the springs into the holes in the 1-2
reverse clutch piston assembly.
6. Place J 45184 (1) on the center of J 23456 (2).
7. Place the transmission case cover (19) with the 1-2
reverse clutch piston assembly onto J 45184 (1).
8. Using J 23327-1 (3), which is the bridge part of J
23327, compress the 1-2 reverse clutch piston return
spring assembly (601).
9. Install the 1-2 reverse clutch piston return spring
retaining ring (600) using snap ring pliers.
10. Remove the pressure from J 23456 (2).
11. Remove all tools.
NOTE
Check the position and direction of the 1-2
reverse clutch apply plate (618) before
installation.
12. Install the 1-2 reverse clutch apply plate (618).
NOTE
• Make sure you have the correct number of
clutch plates.
• Make sure the clutch plates are in the
correct order.
13. Install the 6 steel plates (619) and the 6 fiber plates
(620).
14. Install the 1-2 reverse clutch backing plate (621).
NOTE
Check the position of the 1-2 reverse clutch
backing plate retaining ring (622) before
installation.
15. Install the 1-2 reverse clutch backing plate retaining
ring (622) into the groove indicated.
Reference: "Case Cover Assembly Assemble".