Suzuki XL7 2007 Service Manual page 1720

5A-310 Automatic Transmission:
CAUTION
!
Do not use bolts longer than 28 mm. Using
bolts longer than 28 mm will cause internal
damage to the transmission.
11. Install the 8 - M8 x 1.25 x 28 mm fluid pump to case
bolts (5) and hand tighten.
12. Rotate the transmission assembly so that the fluid
pump assembly is facing up.
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
13. Tighten the fluid pump to case bolts in the correct
sequence.
Tightening torque
Tighten the fluid pump to case bolts to 25 N⋅m
(18 lb ft).
Reference: "Control Valve Body Assembly Installation".
Control Valve Body Assembly Disassemble
Reference: "Control Valve Body Assembly Removal".
NOTE
The control valve body is serviced only as an
assembly. Only the following components are
serviced on the control valve body:
• The 5 shift solenoid valves
• The manual valve
The control valve body assembly should only
be disassembled to confirm a diagnostic
symptom.
1. Remove the manual valve (337).
2. Remove the bolt (307), the wiring harness clip (318),
and the TCC lock up pressure control solenoid valve
retainer (319).
3. Remove the TCC lock up pressure control solenoid
valve assembly (339).